Puff Heat Transfer Vinyl

Puff Heat Transfer Vinyl

$12.99

Shipping calculated at checkout

Only 1 left!

100% Satisfaction Guaranteed

Carmen

Approved

Description

Puff Heat Transfer Vinyl

Add a fun 3D look to any design with Puff HTV!

  • Puffs up when pressed- no need for re-pressing to get the puff effect
  • Easy to weed with simple application instructions
  • Pressure-sensitive carrier enables easy weeding and repositioning

Material Specifications

  • 12" x 20" sheet
  • 4.9-6.7 mils/125-170 microns

Cut Settings:

**This material's carrier sheet may look more dull than other standard heat transfer vinyl. The shiny 'wet-looking' side should face up on the mat.**

 Always test cut prior to any production run. For optimal cutting and weeding, maintain a line thickness of at least 1/16" for lettering & logos.

Cricut:

• Blade: Standard
• Setting: Iron-on

Silhouette Cameo:

• Blade: Standard, 3
• Setting: Heat Transfer
Material (Smooth)
• Speed: 8
• Thickness: 6

Scan N Cut:

• Blade: 2
• Cut Speed: 1
• Cut Pressure: 1

Roland GS/GX-24:

• Blade: 45°
• Force: 80g-90g
• Speed: 25-50 cm/s


Application Settings:

WHITE:
Time: 10 seconds
Temperature: 290°F/143°C
Pressure: Medium, even
Peel: Hot

PINK & NEONS:
Time: 10 seconds
Temperature: 275°F/135°C
Pressure: Medium, even
Peel: Hot

ALL OTHER COLORS:
Time: 10 seconds
Temperature: 305°F/151°C
Pressure: Medium, even
Peel: Hot

Material/Fabric Compatibility

  • Cotton, Uncoated Polyester, Fabric Blends, Polyester/Acrylic, and Similar Fabrics. Excluding Nylon

Care Instructions

  • Wash inside-out, cold water, gentle cycle, tumble dry low.

Special Precautions

  • Cannot be layered. Remove carrier immediately after pressing. If the carrier or transfer sheet is left on, it can create inconsistencies in the puffed material.

Check these out too...